Turbo Knitting Machine 5 Minute...ish Beanie
10 months ago
- #DIY
- #Knitting Machine
- #Automation
- Introduction to modifying an Addi Express King Knitting Machine into a turbo knitting machine.
- Initial issue with the machine's cranking handle spigot being broken.
- Decision to automate the machine using a motor to avoid manual cranking.
- List of supplies needed for the modification including a 12V motor, Arduino Nano, and various sensors.
- Design concept involving a DC motor with speed control and a Hall sensor for row counting.
- Challenges faced with motor selection and alignment, leading to the use of a 12V 400 RPM high torque motor.
- Installation of the motor and motor driver, including securing with resin and hot glue.
- Development of an Arduino-based row counter using a TM1637 display and a Hall sensor.
- Testing the modified machine, achieving a beanie knit in 5 minutes and 22 seconds.
- Final thoughts on the successful modification and satisfaction with the project's outcome.